top
logo


Light signal decoder HV-signal system
Article Index
Light signal decoder HV-signal system
Das H/V-Signalsystem und seine Signalbilder
Schalten der Signalbilder
Signal-Hersteller

 


Decoder of the Z1-series (standard and all-in-one classes) are the actual light signal decoder of the Qdecoder. Before using them on the model railway, they need to be configured. In the simplest case this is done with the programming button. However, often an additional programming with configuration variables is required. If signal aspects should be displayed, this programming can get an extensive job.

You can manually configure the decoder yourself, or you acquire a pre-configures Qdecoder-light decoder and save the configuration of the configuration variables.

A unified signal aspect generator was developed for the HV-signal system, which can control different signals via CV400 (-> light signal decoder shop). At least two signals can be controlled in each setting. The function outputs of the decoder are used in full.

CV400 1 2 4 8 16 32 64 128
A0 Hp-6
hp6
Sh1 / Ra12
and
Zs1
separate
Hp-5
hp6
only Sh1 / Ra12
Hp-4
hp4
Vr-4
vr4
Hp-3
hp3
A1
A2
A3 Hp-2
hp2
Light-
output 1
A4 Hp-4
hp4
Vr-4
vr4
Light-
output 2
A5 Hp-3
hp3
Vr-3
vr4
(connected with diodes)
Hp-3
hp3
A6 Hp-2
hp2
A7

The connection to the decoder is shown in the data sheet.

A special case is the variation CV400 = 4. In this case there is not strictly one LED per function output. To control the common H/V exit signals with Sh1 and approach signal (9 lamps) with one decoder, two lamps of the approach signal are connected to function outputs via diodes.

In the case CV400 = 128 two light outputs can be switched with independent addresses instead of a third signal.



 

bottom
top
Register | Login | about us | Shipping and handling | Legal notice | Terms and conditions | Privacy statement | Search

bottom